WeSplurge.com
Sandstone Coaster
Sandstone Coaster
Regular price
$4.25 USD
Regular price
Sale price
$4.25 USD
Unit price
per
Shipping calculated at checkout.
COASTER (SANDSTONE) SUBLIMATION
Supplies needed:
- sublimatable substrate (coaster)
- sublimation transfer
- teflon or scratch paper
- heat tape
- soft paper towel (optional)
Heat press settings:
- temperature - 400 degrees F
- dwell time - 1.5 to 2 minutes
- pressure - light to medium
- The recommended settings above may need adjustments for best results.
Settings will vary depending on the heat press brand and model ink and paper
and atmospheric conditions.
- The layers of soft paper towel achieve two goals: 1. it helps to distribute
the pressure evenly throughout the substrate; 2. it helps to trap ink that is
dispersed outside of the edges of the substrate if there is an overprint area
or full bleed in the artwork.
- Due to the porous nature of this product the image may appear lighter than
other hard subsrates.
Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel
3. substrate
4. transfer
5. teflon sheet or scratch paper
Steps:
1. Position the substrate onto the transfer.
2. Tape the substrate to the transfer using the heat tape.
3. Place the transfer and substrate in the press onto the paper towel
(transfer on top of substrate).
4. Place a teflon sheet or scratch paper on top.
5. Press the items using the settings listed above.
6. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.
7. Tear the transfer in half opposite of the taped ends.
Tips:
- If the image of the final product appears too light increase the pressure
or the dwell time slightly (5-15 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed reduce the dwell time slightly (5-15 seconds).
Supplies needed:
- sublimatable substrate (coaster)
- sublimation transfer
- teflon or scratch paper
- heat tape
- soft paper towel (optional)
Heat press settings:
- temperature - 400 degrees F
- dwell time - 1.5 to 2 minutes
- pressure - light to medium
- The recommended settings above may need adjustments for best results.
Settings will vary depending on the heat press brand and model ink and paper
and atmospheric conditions.
- The layers of soft paper towel achieve two goals: 1. it helps to distribute
the pressure evenly throughout the substrate; 2. it helps to trap ink that is
dispersed outside of the edges of the substrate if there is an overprint area
or full bleed in the artwork.
- Due to the porous nature of this product the image may appear lighter than
other hard subsrates.
Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel
3. substrate
4. transfer
5. teflon sheet or scratch paper
Steps:
1. Position the substrate onto the transfer.
2. Tape the substrate to the transfer using the heat tape.
3. Place the transfer and substrate in the press onto the paper towel
(transfer on top of substrate).
4. Place a teflon sheet or scratch paper on top.
5. Press the items using the settings listed above.
6. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.
7. Tear the transfer in half opposite of the taped ends.
Tips:
- If the image of the final product appears too light increase the pressure
or the dwell time slightly (5-15 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed reduce the dwell time slightly (5-15 seconds).
Couldn't load pickup availability
