Sublimation Card Holder

Sublimation Card Holder made of P/U Leather

Approximately 2.9 inches in length by 4.6 inches in width
Approximately 1.20 oz in weight
Approximately 2mm thick
1 card Slot
Made of P/U Leather
The printable area is white matte

Suggested Press instructions:

Temperature: 400 F
Time: 30 seconds
Pressure: Medium
NOTE:

The recommended settings above may need adjustments for the best results. Settings will vary depending on the heat press brand and model ink and paper and atmospheric conditions.

The substrate should be at room temperature